| 3 Phase Supply Voltage: | U2IN = 208...240 V ± 10 % U3IN = 380...415 V ± 10 % U5IN = 380...500 V ± 10 % U6IN = 525...690 V ± 10 % |
| Frequency: | 48...63 Hz |
| Short Circuit Capacity: | 50 kA 1 s |
| Power Factor: | cos1 = 0.97 (fundamental) cos = 0.93...0.95 (total) |
| Degree of Protection: | IP 21 (Standard for ACS 607) IP 22 (Standard for ACS 601, Optional for ACS 607) IP 42 (Optional) IP 54 (Optional, derating required for ACS 601) IP 54R (R = flange for air duct, optional only for frames R11i and larger) |
| Paint Color: | ACS 601/604 Light beige NCS 1502-Y (RAL 90021/PMS 420C), Black ES 900 (ACS 601 Frame sizes R2...R6) ACS 607 Light beige RAL 7035 semi gloss |
| At Nominal Power: | 98 % |
| 3 Phase Output Voltage | 0...U2IN/3IN/5IN/6IN |
| Frequency Control | 0...±300 Hz 0...±120 Hz with du/dt filters |
| Field Weakening Point: | 8...300 Hz |
| Motor Control Software: | ABB's Direct Torque Control (DTC) |
| Torque Control: | Torque step rise time |
| Open Loop | <5 ms with nominal torque |
| Closed Loop | <5 ms with nominal torque Non-linearity: |
| Open Loop | ±4 % with nominal torque |
| Closed Loop | ±1 % with nominal torque |
| Speed Control | Static accuracy |
| Open Loop | 10 % of the motor slip |
| Closed Loop | 0.01 % of the nominal speed Dynamic accuracy |
| Open Loop | 0.3...0.4 %sec. with 100 % torque step |
| Closed Loop | 0.1...0.2 %sec. with 100 % torque step |
| Ambient Temperature: | Transportation: -40...+70 °C Storage: -40...+70 °C Stationary use: 0...+40 °C (+50 °C by derating, see figure below) |
| Relative Humidity: | 5...95 %, no condensation allowed |
| Cooling Method | Dry Clean Air |
| Altitude: | 0...1000 m ASL No derating required. 1000...4000 m ASL Derating required. |
Imax = IN,40C  (100 % - 1 % |
 |
+ x (40°C - Tamb)) |
| x | = 1,5 % / °C ACS 607 |
| x | = 3,5 % / °C ACS 601 |
| h | = altitude above sea level > 1000 m |
| IN,40C | = ACS 600 nominal current at 40 °C |
| Tamb | = maximum ambient temperature, Note: Imax < or = IN,40C |